@danman wrote:
Hi,
I am a newbie, but after one week of reading i got very good and stable values with reachview beta. I bought your starting set. I always get a fix for the rover and it works really nice with high accurency. Here is my Setup and my problem.
Base(reach with reachview beta):
Single w fix&hold. All gnss on. No glossnass AR. All 5hz. Good skyview. Most of the time 7 sats green.
Rover(reach with reachview beta):
Kinematic w fix&hold. TCP client to base. 5hzI always get a fix after a few minutes....So reach works and of course i have a ground plate.
My problem is the height values. In the view and logs of the rover and the base i receive wrong height values. I know a controlpoint a few meters next to the base. It is about 530m over NN. It an official measurement point.
The gps values i receive are always about 575m. The value is very stable but wrong...and i get it everytime wrong. Do I have to the base to manual and edit the height? What shold i do?The ellipsoid height is the problem. Can i adjustment it to the right value? Is this value also corrected on the rover?
I found a different post in the forum but obviously it is not the same problem.Regards
dan
Posts: 2
Participants: 1