@Upperfoot wrote:
Hello everyone,
I am having an issue where I am trying to calibrate my ESC's through APM on my new Navio2, I am doing the following.
- Run Arducopter to connect to APM
- Arducopter connected to Mission Planner
- Navigate to ESC Calibration under "Mandatory Hardware" in "Initial Setup" on Mission Planner
- Make sure power to ESC is disconnected (currently have power using power module).
- ESC connectors are set to servo headers 1,2,3,4. Only one ESC connector provides power, the other three only signal.
- Radio throttle is set to high (1700) - I am using the Joystick for this as I don't have a radio.
- Click ready button to run ESC calibration
- Connect power to ESC
At this point the raspberry PI crashes, there is nothing in the logs and it reboots itself.
I am running a 4S 5800mah 25c LiPo and the ESC module I am using is the Q-Brain 25a
Any help would be appreciated, I can't do anything with it at the moment
Posts: 1
Participants: 1