@cndnflyr wrote:
I've been able to trigger my sony camera with a Skysight Mono using PWM signals from a Raspberry Pi. I would like to do the same thing with the Reach, but I'm not sure if it's possible. I found some modules that would fit on the Edison, but because the Reach is in the way, I'd need to do it with the output options already there. On the RPi there was an option to use Software controlled PWM. Does anyone know if this has been done with the Edison/Reach?
Also, I was hoping someone could point me towards some information about using the GPS timestamp pin to timestamp the photo's gps position. Sorry! I know this is planned, but at least an idea of what hardware it would take would be helpful. Right now I have a Sony A5100, with no hotshoe, so I think I'd have to get a different camera to use this.
Another option I have is to use the RPi and connect it with the Edison to get the GPS info. What would be the best way to do this? I'm not too familiar with the RPi, so any pointers would be helpful.
Posts: 1
Participants: 1