@gdasher wrote:
I have two new Reach RS+ units. Initial setup went well. Latest firmware and Reachview software installed. I did notice some intermittent WiFi connectivity issues, but we were having issues on our corporate network and I attributed it to that.
I followed the tutorial on setting up the RS+ for Base/Rover config. However, once I relocated outdoors to finish the config and do some testing, I was unable to connect to the devices. I tried 4 different devices, the internal WiFi will show up and connect and then drop. It continues to do this but never staying connected for more than a couple of seconds. I have used the forget network and added it back.
Now it is telling me incorrect password. I have not modified the default emlidreach password. I am back in my office and both units did not connected to the corporate network and are in hotspot mode upon restart. Since I cannot connect to them and they are not connecting to the corporate network I am stuck.
Any ideas on what to do or try next? How do you factory reset them? Anyone seen this behavior?
Posts: 3
Participants: 3