@tranquility wrote:
Hello all,
I have a raspberry3 with navio2 running ardupilot.
My Receiver is a x4r from frysky, capable of transmitting telemetry Data to my Transmitter.
I’ve read a lot about smart Port Cables and Converter to uart. But i’m still confused.
All desriptions in ardupilot Wiki refer to a pixhawk flightcomputer.
Do you have any suggestions which cable or converter i need, to connect my Receiver to my raspberry / navio2.My Receiver was shipped with a cable for the smartport (4 pins), the cable has a 3 pin connector on the other side (one pin isn’t connected). Can i use this cable? And where to plug on my flightcomputer?
Thanks and Greetings
Posts: 2
Participants: 2
