@DaneGer21 wrote:
Just sharing a few pics of my setup to maybe help others with ideas on where to start, or what to improve from my setups. Nothing major here, and pretty basic, DIY and cheap was my number one goal here.
Sure, it’s not “professional” looking, but it works great!
Base…
2.5"x5" Tupperware container
- lined with copper tape
Rmrc 5/6v bec with on/off switch
Reach module
- standard/included antenna
3dr clone radio
- OTG/USB
1100mah 3s battery
Basic 82" tripod
- set at 78"(top of ground plane to match rover)
Clamp on bubble level
6" ground plane
- lined with copper tape
5" acrylic dome
Random zip ties
Rover…
2.5"x5" Tupperware container
- lined with copper tape
Rmrc 5/6v bec with on/off switch
Reach module
- standard/included antenna
3dr clone radio
- df13 plug
1100mah 3s battery
3/4" pvc pipe
- caps on each end
- small machine screw out the bottom to act as a “point”
- small machine screw out of the top to hold ground plane
- total height to top of ground plane is 78"
Clamp on bubble level
6" ground plane
- lined with copper tape
5" acrylic dome
Random zip ties
Posts: 1
Participants: 1