@bide wrote:

The purpose here is to show you the basic ReachView settings for PPK.

I have provided screenshots of each tab within ReachView and annotated them in RED writing.

We will not discuss post-processing here, only ReachView settings.

NOTE*

The settings below are exactly the same for base and rover. That is because the choice between base and rover is something that is done afterward when you post-process your log files.

At the bottom of each picture, I have rewritten the English text for people who will be using a language translator.

status_tab.png1389x1210 65.1 KB

(FOR PPK: The only useful information here is the signal-to-noise ratio chart.)

survey_tab.png1031x678 53.2 KB

(FOR PPK: Survey project - point collection is done in single mode and is not useful for accurate coordinates. However, you can use point collection to: a) name each point you occupy, and b) extract the time of day for each point. This could help you find each point within your raw data.)

rtk-settings_tab.png1032x679 57.3 KB

(FOR PPK: Set “GNSS select” options, and “Update rate” options. RTK section: RTK = for RTK only, not PPK! Max acceleration section: for RTK only. GNSS select: for RTK and PPK. Update rate: for RTK and PPK.)

correction_input_tab.png1032x679 42.7 KB

(FOR PPK: Base correction and Additional correction are off.)

position-output_tab.png1032x679 36 KB

(FOR PPK: can be on or off)

base-mode_tab.png1205x802 67.9 KB

(FOR PPK: Corrections output is off. No settings here are used.)

logging_tab.png1053x655 45.9 KB

(FOR PPK: only the “Raw data” log must be on. No other logs are required.)

wifi-bluetooth_tab.png794x665 47.5 KB

(Wi-Fi/Bluetooth section: FOR PPK: WiFi doesn’t matter; can be of or off; hotspot or client mode. Bluetooth section: FOR PPK: Bluetooth doesn’t matter; can be on or off.)

Happily accepting any error corrections or critique on my wording.

Oh, and don’t forget to “” or comment if you found this useful. Thanks!

Posts: 3

Participants: 3

Read full topic