@Alessio_Tusca wrote:
Hello guys, i’m putting my first build together and i want to get it work (at least hover) with my xbox one controller via MAVlink.
I don’t have an RC controller and the autopilot is connected via wifi
I managed to connect the gamepad to mission planner, assign the main channels and do the calibration; however i can’t control the copter (arducopter-hexa). When i try to arm the drone i get always rejected by the autopilot and mission planner says “rc not calibrated” even though the joystick is active and calibrated.
The main problem is that the autopilot doesn’t answer the joystick (motors doesn’t spin) and i can’t arm it because it says “RC not calibrated”.
Also every time i open mission planner and connect it to the navio it messages me about the new version of arducopter 3.5.5, but i did the updating of the autopilot.
Can someone tell me what to do or recommend me a post (i couldn’t find anyone with my problem)?
Thanks and sorry for my poor englishEdit 02/03/18
I managed to see it working trough bypassing the pre-arm checks (but i’ll find out how to get it with all the checks) and i’ve seen that the moment i arm the drone all the motors starts spinning at roughly 70% with the pad in the center. Most likely it’s a bad joystick calibration and i don’t know how to change the parameters manually as it sets those automatically within the calibration.
Posts: 3
Participants: 2
