Voltage, but no current reading with Emlid Power Module

@flyingw wrote:

I installed the power module that came with the Emlid Navio2. Using the latest image from the Emlid website, and ArduCopter 3.4, I configured the settings per the documentation:

volt.JPG700x415 36.9 KB

I also verified that the LIST of parameters showed:

BATT_CURR_PIN 3
BATT_VOLT_PIN 2

I get a good voltage reading on the Mission Planner HUD, but the current reading remains at 0.0A even with the motors throttled up.

I must have missed something - what else should I configure?

Thanks,

Paul

Posts: 2

Participants: 2

Read full topic