@drone_newbie wrote:
Hello again,
as always, i now have a problem setting up the RC failsafe. I am using Turnigy 9XR Pro with a FRSKY DJT transmiter and the popular FRSKY D4R-II receiver.
I was more that confident that everything would work straight ahead, because the procedure I follow in the Enable RC Failsafe! link you provided , also shows a video example that uses the same receiver.. I do exactly what it says which is extremely simple. Even with such simple procedure, my RC failsafe does not work. Before trying to set the RC failsafe i already succesfully performed radio calibration..
I confirmed that RC failsafe does not work by doing in my desk office the following:
- arming the motors in stabilize mode and with the throttle being in zero i turned off the transmitter, The mission planner kept showing armed status.
- arming the motors in stabilize mode and with the throttle in middle i turned off the transmitter. THe mission planner kept showing stabilize mode and motors were still armed. THe motors kept spinning after closing the transmitter
So whats the problem here???
I already tried and used the command that you proposed in another topic sudo cat /sys/kernel/rcio/rcin/ch2
So
1) I turned on both the receiver and the transmitter and moved the throttle stick up.
2) i then ran the command sudo cat /sys/kernel/rcio/rcin/ch2 . It returned a pwm value e.g around 1500
3) then i closed the transmitter and ran the command again. It returned again the same value around 1500.
Obviously the RC failsafe does not work at all..Please could you help me ??
THanks and Regards,
Posts: 1
Participants: 1