Dynamic Telemetry IP address
@hedgey wrote: Anyway to change the telemetry IP address on the fly? Posts: 5 Participants: 4 Read full topic
View ArticleClik here to view.
Reach to Leica GPS1200 results comparison
@Luke_Wijnberg wrote: I finally got around to comparing Reach to our Leica GPS1200 survey grade GPS. This little article tries to explain my methodology and solutions when trying to underake a static...
View ArticleSyncronize Reach with camera trigger
@gaucholino wrote: Hello I wan't to figure out, if I can need reach.I want to do the following:I have a drone with a camera on it. And I want to know the location of the pictures I take. So I thought...
View ArticleI could not created PWM
@harderthan wrote: first, I do not know English well. I have raspberry pi B+ Navio2 bec esc servo power module battery I had set up the latest version Navio2 image and the apm binary.I was executed...
View ArticleClik here to view.
Navio2 Power Module
@lewma wrote: I'm having a difficult time plugging the power module into the power connector on my Navio2 board. Just wondering, is there a single Emlid Power module that is compatible with both the...
View ArticleSend commands to navio2 directly from the rpi
@Bsgiovanini wrote: Hello! I wondering how i could send controls directly from the rpi. I will have a program that will filter the user commands and generate a automatic control based on sensors...
View ArticleNavio2 PWM programmability
@garageguy wrote: Is there documentation on programming the PWM outputs on the Navio2? I'm specifically interested in what is the available frequency range. I'm going to be driving some large brushed...
View ArticleHow long well A REACH RTK KIT be send to China
@zlucas wrote: hello,i am a chinese.and i want to buy a set of Reach Rtk Kit.my question is how long will the set be send to China (Dalian City).thanks. Posts: 3 Participants: 2 Read full topic
View Articlenavio2 stm32 boot pin?
@raph38130 wrote: Dear all, I am looking for navio2 firmware source code and boot pin/pad to flash embedded stm32 if needed... best regards BTW I have done some preliminary tests and everything runs...
View ArticleCannot reach above 15 meters when autopilot
@mayyiineyss wrote: Hello again guys! We are in the process of testing our octocopter now. But we had a problem about reaching above 15 meters altitude. We actually tested its altitude before and it...
View ArticleHow do I go about checking on an order?
@Gary_Balliet wrote: My order shipped Feb 1. It was supposed to arrive Feb 17th (Canada, west cost). Who/how do I find or contact to track it down.An email to support@emlid.com goes unanswered. Posts:...
View ArticleClik here to view.
Grafnav/TBC/.. users here? Need to run a test to support Reach development!
@ivereninov wrote: We are coding the integration of timestamps from Reach to Rinex and would be grateful for a test of compatibility with Grafnav/TBS/Justin or other commercial GNSS post processing...
View ArticleProblems with the Navio2 kernel modules
@Al_B wrote: The kernel module names seem to be “spi-bcm2835” “i2c-dev” “spidev” and a few other modules, but the documentation lists incorrect names on the EMLID site (2708 rather than 2835). After...
View ArticlePi 3 with the Navio Image
@hedgey wrote: Doesn't appear to boot. Green LED flashes 4 long, 4 short pulses. Should I not expect it to? Posts: 1 Participants: 1 Read full topic
View ArticleClik here to view.
Can I use a serial conn for a rover and an internet conn to VRS with ntrip
@LPR wrote: I can see the data from the Reach using putty and I can connect to the VRS but I'm not able to get them to link. I'm not sure that it's possible to use the Reach serial port with the VRS...
View ArticleUsing 3DR Radio telemetry with navio2
@engharsha wrote: how to use 3dr radio telemetry with navio2? Posts: 4 Participants: 2 Read full topic
View ArticleNavio2 Pi 2B 20160212 Img not working
@Richard_Wright wrote: Hi I tested my new Navio2 Board and it connects fine to the mission planner when i use the emlid-raspberrypi2-raspbian-navio2-20160203,ing but fater upgrading to the more recent...
View ArticleDoes Navio 2 compatible with Raspberry pi 3 model B?
@Vithmeesky wrote: I want to know does does Navio 2 compatible with Raspberry pi 3 model B latest release or not Posts: 3 Participants: 2 Read full topic
View ArticleClik here to view.
Reach float vs fix
@dmiles264 wrote: I am having trouble getting good satellite on my reach rover. Do you have some good recommendations for improving the signal level performance? I am typically in "float" mode and...
View ArticleGPS and Baro Problem
@palacita wrote: Hi Community, I have still an GPS and Baro problem with NAVIO+ flashed with http://docs.emlid.com/navio/Downloads/Real-time-Linux-RPi2/ use sudo ArduCopter-quad -C /dev/ttyAMA0...
View Article
