Product inquiry
@palffyandras wrote: Hi every one, we are new to the positioning game. I have the following task: I need to know the relative (only the relative) position of a pedestrian/biker to a moving car with a...
View ArticleHelp/ayuda
@kingping247 wrote: hello good day I’m new in these and from Mexico and I have an emlid reach rs + team but I have a problem I could not match the antennas in android to do RTK I do not know how to do...
View ArticleNeutis N5- Getting A working Yocto build
@0xffff wrote: I received my Neutis Dev Kit in yesterday. A very nicely build board. Has anyone gotten the instructions on how to “Build your own Linux OS” here. to work ? and as a side note, why...
View ArticleReachview - Great work! and some suggestions
@Dave wrote: Hi All, I’ve been working with a pair of Reach RS+ for a few weeks now for surveying in a base-rover configuration using the LoRa radio, with the base on known coordinates in manual mode....
View ArticleREACH mm ACCURACY
@neganthesavior wrote: Hello everyone, I’m about to buy two reach units for ground control points for drone mapping in my country Bolivia. I was wondering if there’s a chance to get milimitre...
View ArticleAntenna calibration
@ojedajairo wrote: Hello Emlid team, In my country to do work that can be presented at the geographic institute, it requires that equipments appear on this page: https://www.ngs.noaa.gov/ANTCAL/ My...
View ArticleReach RS overwriting not collecting new data
@jnrobertson wrote: Yesterday, I noticed how the solution file of the Reach RS I am using did not store new data since the 5th of September 2018. I noticed two distinct problems: First of all, before...
View ArticleClik here to view.
Reach M+ Experience: sub-centimeter level accuracy
@kapejod wrote: Hi, i just wanted to share my experience with two Reach M+ which work great in a RTK setup. Both devices connect to a wifi hotspot (or rather two hotspots). The stationary base sends...
View ArticleComparison between straight PPK from NTRIP RINEX and base-RINEX
@jurijs.jeshkins wrote: I was going to process some results from our last expedition to Iceland and found one very strange thing. Our workflow in the expedition was as following: We were placing one...
View ArticleCollection points in QGIS
@And_Nz wrote: I not have problems to connecting the Reach to my QGIS, by GPS Information Panel, but for save points, do not is a tools effective to me. There is some Qgis Plugin with which save...
View ArticleReach and Reach Rs
@v.muscio wrote: Hi friend… … i have 2 reach emlid that comunicate with a radio rfd (europe transmission). i would like to buy a reach rs, if possible to use 2 base for correction (reach emlid) a...
View ArticleClik here to view.
In the USA? Using RTN? And ArcGIS Collector? Read This
@electricblue wrote: OK I’ve finally got this thing figured out. I just collected some data that was off 1.2cm, thats a ‘maybe I didn’t quite level the pole perfectly’ type error, altitude was off the...
View ArticleNavio2 error issue!
@mjc1521 wrote: Hello all, I am currently new at building my own drone. I am having an issue with my Navio2. I have used the command sudo nano /etc/default/arducopter to set my TELEM 1 to my IP...
View ArticleClik here to view.
Reach M+ wiring with Foxtech A7R
@AeroScan wrote: I am trying to set up a Foxtech A7R camera (modified Sony A7R) with Reach M+ for PPK. A diagram of the camera wiring harness is below. I am powering the Reach M+ through S1 pins 1 and...
View ArticleWhen the signal tracking L2 will be included in Reach RS + ...?
@juanluischq wrote: Good morning, dear friends, I am new to this community and I have certain doubts: Having a base control point at a distance of approximately 60 km, as I can link two Reach RS + in...
View ArticleUsing Webcam (UVC camera) on Emlid Edge with GCS
@fako wrote: Hi everybody, I’ve searched for a long time about how to use a USB camera on Emlid Edge. But I’m still stuck. I’ve connected a USB camera on Edge’s USB 1 port. The device is available...
View ArticleReach M+ and Phantom 4 shutter timing. Anyone figured it out?
@wsurvey wrote: Hello, I have made my own rig to carry a reach M+, antenna and usb battery around in order to PPK my mission. I’m just extracting elevations and positions from the PPK track. Without...
View ArticleClik here to view.
Introducing LoRa Radio for Reach M+
@dmitriy.ershov wrote: Today we release the long-awaited LoRa radio for Reach M+! LoRa-M-768x562.jpg768x562 21.4 KB The new radio module works at the same frequency range as Reach RS/RS+ LoRa...
View ArticleThere is no cfs_period_us or cpu.cfs_quota_us in the cgroup
@zivyfeng wrote: Hi guys, I recently use cgroup to limit the resources, while when I install cgroups-lite, it shows $ sudo apt install cgroups-lite Reading package lists… Done Building dependency tree...
View ArticleClik here to view.
Issue with battery on Reach RS
@arsl wrote: Hi, We have a similar problem with one of our Reach units where even if we leave it charging overnight the power doesn’t seem to increase beyond 50% when unplugged and then drains very...
View Article