@liam.wright wrote:
Hi,
I’m attempting to establish a link via Reach RTK (rover) & Reach RS (base), via 3dr 915 mhz radio (on rover), and Jdrones 915 mhz radio (base). This combination of radio has been used successfully to provide telemetry for one of our UAVs.
I have successfully established coms with grey correction bars via the TCP option, however when working across serial, I’m having no luck. Both units are operating with Reachview v2.14.0.
The configuration is as follows in the screenshots. I am working in New Zealand, FYI.
Reach RS (Base):
Reach RTK (Rover):
Any suggestions would be appreciated.
Thanks,
Liam
- Firmware image and ReachView version.
- System report.
- Detailed problem description. How does observed behavior differ from the expected one?
- Your step by step actions.
- Picture of the setup and connection scheme.
- Specify the exact make and model of the hardware you are integrating.
Posts: 1
Participants: 1