@ashley.walker wrote:
Hello,
I have setup up the rover to log (and then process?) to RINEX v2.11 but it is getting stuck at 99% complete (see screen shot).
I have had the rover setup in the office at the moment connected to the wifi for over an hour and it has been stuck at the 99% for about 30 minutes. Any ideas/tricks to get it moving or how long I should let it run.
Firmware: 2.14.0
The UBX file for this one can be found here: https://bit.ly/2vYD7nw
(shortened link to Sharepoint because I can’t upload it here) in case someone can spot something in the file.
Posts: 3
Participants: 2