@Arun_Kumar_Surisetty wrote:
I’m a new user to the Reach Rtk and RS in India. I had gone through all the steps to setup a reach rs or simple reach. I understood that we require a wifi or a mobile hotspot to update the firmware for the first time. In case where home or office wifi is not available, we can rely on mobile hotspot wifi. However, in the second case we require two devices (mobile+mobile or mobile+laptop). It would have been better if there is no requirement that the both reach and mobile/laptop to work on the same wifi.
If everything can be possible with only one mobile which already has internet (4g/3g) to update the reach firmware, it would be great.
I didn’t understand the logic in putting both the devices i.e. reach and the mobile on same network if it has to upgrade the firmware in reach.
As the mobile already has 4g, when the reach searchers for wifi, it can directly take the data from the mobile hotspot while the mobile (controller here) stil can use it’s own mobile data. I’m facing difficulty to get two devices to start with.
Can anyone comment
Posts: 3
Participants: 2
